|
BO - 5 |
BO
- 6F |
| 
|
 |
- Sealless steel strapping
tool. BO-5 is especially designed for strapping flat
objects e.g. boxes, bricks, timber products, goods stacked
on pallets, etc.
- The tool is adjustable for
straps of a width of 13 - 20mm and a thickness of
0.4- 0.6mm.
|
-
Tool BO-6
is advanced type based on BO-5.
-
It is 0.75kg
lighter, operation is easier and better ergonomic shape
of levers enables to work easier also in vertical position.
-
Improved
body design increases its lifetime.
-
Other technical
parameters are similar to BO-5.
|
|
Click
here for "Directions
of use" |
|
Options
and non-standards |
- metal cover
- extra strong tightening
disk with cross tooth system
|
|
^TOP |
|
BO - 6PN |
|
 |
- Sealless steel strapping
tool with pneumatic tightening.
- The tool is adjustable for
straps of a width of 13 - 20mm and a thickness of
0.4 - 0.6mm.
- The tool is designed for
frequently performed strapping jobs.
|
|
^TOP |
|
|
 |
Wind the
strap around the goods to be strapped from top to the bottom
keeping the other end of the strap in the decoiler. |
 |
Hold the
levers and press them against one another to open the tool
(the tightening disk will remove from the die) and then insert
the strap into the tool to the stops. |
 |
Tighten the
strap by clockwise motion of the tightening lever so that
the required tension is achieved.
NOTICE: For fast strapping it is possible to twitch the upper
strap back from the strapping tool.
CAUTION - operate only while wearing protective gloves!
|
 |
When the
strap is tightened enough, return the tightening lever to
the basic position. Turn the cut off lever forward against
the tightening lever to create the joint and cut the surplus
strap. |
 |
Hold the
levers and press them against one another to release the strap
from the tool. |
|
^TOP |
